Hyundai Accent: Power Door Lock Actuators. Repair
procedures
Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Actuators. Repair
procedures
Inspection
Front Door Lock Actuator Inspection
| 1. |
Remove the front door trim.
(Refer to the BD group - "Front door")
|
| 2. |
Remove the front door latch.
|
| 3. |
Disconnect the 5P connector from the actuator.
|
| 4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
Rear Door Lock Actuator Inspection
| 1. |
Remove the rear door trim.
(Refer to the BD group - "Rear door")
|
| 2. |
Remove the rear door latch.
|
| 3. |
Disconnect the 5P connector from the actuator.
|
| 4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
Front Door Lock Switch Inspection
| 1. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
| 2. |
Remove the front door latch.
|
| 3. |
Disconnect the 5P connector from the actuator.
|
| 4. |
Check for continuity between the terminals in each switch position
when inserting the key into the door according to the table.
|
Rear Door Lock Switch Inspection
| 1. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
| 2. |
Remove the rear door latch.
|
| 3. |
Disconnect the 5P connector from the actuator.
|
| 4. |
Check for continuity between the terminals in each switch position
according to the table.
|
Components and Components Location
Component Location
1. Driver power window switch
2. Door lock switch
3. BCM (Body Control Module)
4. Front door lock actuator
5. Rear door lock actuator
6. I ...
See also:
Reassembly
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boots.
2.
Apply grease to the joint boot on the side of the wheel an ...
Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several
years. When replacement is necessary, use the following procedure.
1. Insert a slim tool into the slot and gentl ...
Jump starting
Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm
to yourself or damage to your vehicle or battery, follow the jump starting procedures.
If in doubt, we strongly recomme ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com