If a large amount of unburned gasoline flows into
the converter, it may overheat and create a fire hazard. To prevent
this observe the following precautions and explain them to your customer.
|
1. |
Use only unleaded gasoline.
|
2. |
Do not run the engine while the car is at rest for
a long time. Avoid running the engine at fast idle for more than 10minutes
and idle speed for more than 20 minutes.
|
3. |
Do not measure engine compression for an extended
time. Engine compression tests must be made as rapidly as possible.
Remove the fuel pump relay before performing a compression test.
|
4. |
Do not dispose of used catalytic converter together
with parts contaminated with gasoline or oil.
|
SRS Control Module (SRSCM). Description and
Operation
Description
The primary purpose of the SRSCM (Supplemental Restraints System Control
Module) is to discriminate between an event that warrants restraint system deployment
and an event that d ...
Installation
1.
Dowel pin of crankshaft should be positioned at 3В°
in relation to vertical center line.
2.
Align the TDC marks (A) of the CVVT ...
Troubleshooting
Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
...