Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / Seat Belt Pretensioner / Anchor Pretensioner (APT). Repair procedures / Removal

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Remove the seat belt after pushing the lock pin (A).

3.

Remove the following parts. (Refer to the Body group-Interior trim)

A.	Door scuff trim

B.	Center pillar trim

4.	Disconnect the anchor pretensioner connector (A).

5.	Loosen the anchor pretensioner mounting bolt (B) and remove the anchor pretensioner.

Anchor Pretensioner (APT). Repair procedures

...

Installation

1. Remove ignition key from the vehicle. 2. Disconnect the negative (-) cable from battery and wait for at least three minutes. ...

See also:

Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Specifications
Specifications Direct control VFS[OD/B] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.5 ~ 0.1, 7.82 ~ 1.42) ...

Windshield wipers
Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, push the lever upward and release it with the lever in the OFF position. The wipers will operate continu ...

Driving off-road
Drive carefully off-road because your vehicle may be damaged by rocks or roots of trees. Become familiar with the off-road conditions where you are going to drive before you begin driving. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com