Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Indicators And Gauges / Instrument Cluster. Repair procedures / Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the cluster fascia panel (A) after disconnecting the trip switch connector(B).

3.	Remove the cluster fascia (A) from the crash pad after removing 4 screws.

4.	Disconnect the cluster fascia connecters(A) and then remove the cluster.

Inspection

Speedometer 1. Adjust the pressure of the tires to the specified level. 2. Drive the vehicle onto a speedometer tester. Use wheel chocks ...

Installation

1. Connect the cluster connector. 2. Install the cluster assembly. 3. Connect the trip switch connector. ...

See also:

SS-B Solenoid Valve(ON/OFF). Description and Operation
Description SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve body. ...

Sunvisor
Use the sunvisor to shield direct light through the front or side windows. To use a sunvisor, pull it downward. To use a sunvisor for a side window, pull it downward, unsnap it from the bracket ...

Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly distribute the sealant in the tire. Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com