1. |
Remove the mirror (A) from the mirror holder. Be careful not to
damage to the clip.
|
2. |
Remove the mirror cover (A).
|
3. |
Disconnect the mirror connector (A). Remove the door mirror turn
signal lamp (B) after loosening screw.
|
Installation
1.
Installation is reverse of removal.
Accelerator pedal
module installation nut:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6
...
Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Lift the vehicle.
3.
D ...