Hyundai Accent Manuals

Hyundai Accent: Removal - Hazard Lamp Switch. Repair procedures - Lighting System - Body Electrical SystemHyundai Accent: Removal

1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia garnish (A).

3.
Disconnect Hazard lamp switch connector (A).

4.
Remove the switch cover (A).

5.
Remove the hazard lamp switch (A) after removing the air conditioner switch and rear defogger switch.


Hazard Lamp Switch. Repair procedures
...

Installation
1. Install the hazard lamp switch. 2. Connect the connectors. 3. Install the center fascia garnish. ...

See also:

Replacement
1. Remove the front wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

SS-A Solenoid Valve(ON/OFF). Description and Operation
Description SS-A solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed at valve body. ...

Crankshaft Position Sensor (CKPS). Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the eng ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com