Hyundai Accent Manuals

Hyundai Accent: Removal - Oil Pan. Repair procedures - Lubrication System - Engine Mechanical SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Mechanical System / Lubrication System / Oil Pan. Repair procedures / Removal

1.
Remove the under covers (A).
Tightening torque:
6.9 ~ 10.8N.m (0.7 ~ 1.1kgf.m, 5.1 ~ 7.9lb-ft)

2.
Drain engine oil.
3.
Using the SST(09215-3C000) and remove the oil pan.

•
Insert the SST between the oil pan and the ladder frame by tapping it with a plastic hammer in the direction of arrow.
•
After tapping the SST with a plastic hammer along the direction of edge of the oil pan, remove it from the ladder frame. arrow around more than 2/3 edge of the oil pan, remove it from the ladder frame.
•
Do not turn over the SST abruptly without tapping. It be result in damage of the SST.

Oil Pan. Repair procedures
...

Installation
1. Install the oil pan. (1) Using a razor blade and gasket scraper, remove all the old packing material from the gasket surfaces. ...

See also:

Driving off-road
Drive carefully off-road because your vehicle may be damaged by rocks or roots of trees. Become familiar with the off-road conditions where you are going to drive before you begin driving. ...

Front Impact Sensor (FIS). Components and Components Location
Components ...

Crankshaft Position Sensor (CKPS). Troubleshooting
Waveform This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com