Hyundai Accent Manuals

Hyundai Accent: Removal - Crankshaft Position Sensor 
(CKPS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt.


Inspection
1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform� ...

Installation
• Install the component with the specified torques. • ...

See also:

Engine compartment fuse replacement
1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling up. 3. Check the removed fuse; replace it if it is blown. To remove or insert ...

Rear combination light bulb replacement (4 Door)
(1) Stop and tail light (2) Rear turn signal light (3) Back-up light (4) Side marker 1. Open the trunk lid. 2. Remove the service cover by pulling out the service cover. 3. Remove the sock ...

Inspection
Rear Brake Disc Thickness Check 1. Check the brake pads for wear and fade. 2. Check the brake disc for damage and cracks. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com