Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Knock Sensor (KS). Repair procedures / Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).

3.	Disconnect the injector connector (A).

4.	Remove the installation bolt (B), and then remove the sensor from the cylinder block.

Knock Sensor (KS). Repair procedures

...

Installation

• Install the component with the specified torques. • ...

See also:

Side Impact Sensor (SIS). Description and Operation
Description The Side Impact Sensor (SIS) system consists of two front SIS which are installed inside the Center Pillar (LH and RH). They are remote sensors that detect acceleration due to co ...

Wipers and washers
A :Wiper speed control · MIST – Single wipe · OFF – Off · INT – Intermittent wipe · LO – Low wiper speed · HI – High wiper speed B : Intermittent wipe time adjustment C :Wash w ...

Intake Air Temperature Sensor (IATS). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between th ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com