Hyundai Accent Manuals

Hyundai Accent: Repair procedures - Manual Transaxle System - Manual Transaxle System (M6CF1)Hyundai Accent: Repair procedures

Inspection

Manual Transaxle Oil Inspection
1.
Park the vehicle on a level ground and stop the engine.
2.
Retighten the oil filler plug (A) with a new washer.

3.
Check level with finger.
Oil level must be up to fill the hole, if not, add oil until it runs over.

4.
Install the filler plug with a new gasket.

Tightening torque:
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.8 lb-ft)

Manual Transaxle Oil Replacement
1.
Park the vehicle on a level ground and stop the engine.
2.
Drain the manual transaxle oil after loosening the drain plug (A).

3.
Intall the drain plug with a new gasket

Tightening torque:
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.9 lb-ft)

4.
Add new oil through the filler plug hole and, fill it just below the plug opening.

Standard oil: SAE 75W/85, API GL-4
Oil capacity: 1.8 ~ 1.9L (0.48 ~ 0.50 U.S.gal., 1.90 ~ 2.01 U.S. qt., 1.58 ~ 1.67 lmp qt.)


Manual Transaxle System
...

Manual Transaxle. Components and Components Location
Components 1. Transaxle support bracket 2. Control shaft complete 3. Back up lamp switch 4. Speedmeter ...

See also:

Windshield wipers
Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, push the lever upward and release it with the lever in the OFF position. The wipers will operate continu ...

Engine compartment fuse replacement
1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling up. 3. Check the removed fuse; replace it if it is blown. To remove or insert ...

Checking the tire inflation pressure
1.After driving approximately 4~6miles (7~10km or about 10min), stop at a safety location. 2.Connect connection hose (9) of the compressor directly to the tire valve. 3.Plug the compressor power c ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com