Hyundai Accent Manuals

Hyundai Accent: Replacement - TPMS Sensor. Repair procedures - Tire Pressure Monitoring System - Suspension SystemHyundai Accent: Replacement

Repair tire after using the Tire Mobility Kit (TMK)
When the TPMS warning lamp OFF
1.
Remove the TMK repaired tire, wheel and TPMS sensor.
(Refer to "Tire removal")
2.
Remove the sealant on the wheel and TPMS sensor (A) completely.
•
Clean the sealant on the housing and sensing hole of TPMS sensor with clean cloth, gauze or air inhalers.
•
To prevent the sensor and circuit board damage, do not use the pointed instrument and give a lot of impact.

3.
Install the TPMS sensor to the new tire.
4.
Check that the normal operation of TPMS system.
When the TPMS warning lamp ON
1.
Remove the TMK repaired tire, wheel and TPMS sensor.
(Refer to "Tire removal")
2.
Remove the sealant on the wheel and TPMS sensor (A) completely.
•
Clean the sealant on the housing and sensing hole of TPMS sensor with clean cloth, gauze or air inhalers.
•
To prevent the sensor and circuit board damage, do not use the pointed instrument and give a lot of impact.

3.
Install the TPMS sensor to the new tire.
4.
Check the tire pressure using the electrical tire pressure gauge.
5.
Check the tire pressure of TPMS sensor using the GDS
6.
If the difference between two checked pressures in the above is not more than 2 psi, TPMS sensor is normal. Reinstall it to new tire.
7.
If the difference between two checked pressures in the above is more than 2 psi, TPMS sensor is abnormal. Install new TPMS sensor to new tire.
8.
Check that the normal operation of TPMS system.

Removal
Handle the sensor with care. 1. Remove the tire. (Refer to "Tire Removal") ...

Installation
Sensor Fit • Handle the sensor with care. • ...

See also:

Side Airbag (SAB) Module. Description and Operation
Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airba ...

Check spark plugs and ignition system
Inspect your spark plugs as described in section 7 and replace them if necessary. Also check all ignition wiring and components to be sure they are not cracked, worn or damaged in any way. ...

Hands free mic. Repair procedures
Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - "Roof trim") ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com