Hyundai Accent: Schematic Diagrams

PODS-F Zeroing procedure

You should perform PODS-F Re-zero procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly) 1. Ignition “OFF” ...

Circuit Diagram (1)

...

See also:

Output Speed Sensor. Troubleshooting
Signal Waveform Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Sliding the sunroof
To open or close the sunroof (manual slide feature), pull or push the sunroof control lever backward or forward to the first detent position. To open the sunroof (autoslide feature), press the su ...

Engine compartment fuse replacement
1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling up. 3. Check the removed fuse; replace it if it is blown. To remove or insert ...