Description
Never attempt to measure the circuit resistance of the Seat Belt
Pretensioner (BPT) even if you are using the specified tester. If the
circuit resistance is measured with a tester, the pretensioner will
be ignited accidentally. This will result in serious personal injury.
|
Removal
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical group - "Battery")
...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Installation
1.
Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve
upward.
2.
Install the water inlet fitting ( ...