Hyundai Accent: Side Impact Sensor (SIS). Description and Operation

Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH).

Side Pressure Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.

Side Impact Sensor is also called A-SIS because it detects acceleration.

SRSCM decides deployment of the airbag and the time of deployment through the collision signal of the SIS when the collision occurred.

Installation

• Do not turn the ignition switch ON and do not contact the battery cable while replacing the ...

Side Impact Sensor (SIS). Components and Components Location

Components ...

See also:

Measurement Method
Projected Dimensions 1. These are the dimensions measured when the measurement points are projected into the reference plane, and are the reference dimensions ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line (Refer to ...

Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group) 2. Remove the under cover (A). ...