Hyundai Accent: SRS Control Module (SRSCM). Description and
Operation
Description
The primary purpose of the SRSCM (Supplemental Restraints System Control
Module) is to discriminate between an event that warrants restraint system deployment
and an event that does not. The SRSCM must decide whether to deploy the restraint
system or not. After determining that pretensioners and/or airbag deployment
is required, the SRSCM must supply sufficient power to the pretensioners and
airbag igniters to initiate deployment.
The SRSCM determines that an impact may require deployment of the pretensioners
and airbags from data obtained from impact sensors and other components in conjunction
with a safing function.
The SRSCM will not be ready to detect a crash or to activate the restraint
system devices until the signals in the SRSCM circuitry stabilize.
It is possible that the SRSCM could activate the safety restraint devices
in approximately 3 seconds but is guaranteed to fully function after prove-out
is completed.
The SRSCM must perform a diagnostic routine and light a system readiness
indicator at key-on. The system must perform a continuous diagnostic routine
and provide fault annunciation through a warning lamp indicator in the event
of fault detection. A serial diagnostic communication interface will be used
to facilitate servicing of the restraint control system.
See also:
Line Pressure Control Solenoid Valve. Description and Operation
Description
line pressure control solenoid valve is attached to the valve body. This
variable force solenoid valve directly controls the hydraulic pressure inside
the line pressure.
...
Opening the hood
1.Pull the release lever to unlatch the hood. The hood should pop open slightly.
WARNING
Open the hood after turning off the engine on a flat surface, shifting
the shift lever to the P(Park) po ...
Trunk Trim. Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
...