Pressure Side Impact Sensor |
|
1. |
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
|
2. |
Remove the front door trim.
(Refer to the Body group - "Front door")
|
3. |
Disconnect the pressure side impact sensor connector (A) and remove
the pressure side impact sensor mounting screws (B).
|
1. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
2. |
Remove the seat belt after pushing the lock pin (A).
|
3. |
Remove the door scuff trim.
(Refer to the Body group - "Interior trim")
|
4. |
Remove the center pillar trim.
(Refer to the Body group - "Interior trim")
|
5. |
Disconnect the side impact sensor connector (A).
|
6. |
Loosen the side impact sensor mounting bolt (B) and remove the
side impact sensor.
|
Windshield defrosting and defogging
WARNING - Windshield heating
Do not use the or
position during cooling operation in
extremely humid weather. The difference between the temperature of the outside air
and that of the windshie ...
Electrical System
1.
Be sure to disconnect the battery cable from the
negative (-) terminal of the battery.
2.
Never pull on the wires when disconnecting con ...
Emergency starting
Connect cables in numerical order and disconnect in reverse order. ...