Hyundai Accent: Seat Belt Buckle Switch (BS). Description and Operation

The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and uses chassis ground for the signal return. The buckle status shall modify the SRSCM deployment. If the buckle status is unbuckled, the corresponding pretensioner will not be deactivated.

Installation

Pressure Side Impact Sensor 1. Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A). ...

Seat Belt Buckle Switch (BS). Components and Components Location

Components ...

See also:

Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several years. When replacement is necessary, use the following procedure. 1. Insert a slim tool into the slot and gentl ...

Installation
1. Install the bulb. 2. Connect the connector and install the trunk trim. ...

Steering wheel audio control
The steering wheel audio control button is installed to promote safe driving. CAUTION Do not operate audio remote control buttons simultaneously. VOLUME (VOL +/-) (1) Press the up button (+) ...