Hyundai Accent Manuals

Hyundai Accent: Installation - Seat Belt Buckle Switch (BS). Repair procedures - SRSCM - Restraint (Advanced)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / Seat Belt Buckle Switch (BS). Repair procedures / Installation

Be sure to install the harness wires so they will not pinch or interfere with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the seat belt buckle switch.
Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)
4.
Install the front seat assembly.
(Refer to the Body group - "Front seat")
5.
Reconnect the battery negative cable.
6.
After installing the seat belt buckle switch, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.

Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. ...

Passive Occupant Detection System (PODS-F). Description and Operation
Description In order to make normal activation of airbag system, SRSCM detects DTC(s) for the Passive occupant detection system (PODS-F). If the seat is occupied, PODS-F detects passenger pr ...

See also:

Inspection
Rotor 1. Check that there is continuity between the slip rings (C). 2. Check that there is no continuity between the s ...

Fuel Pressure Control Valve. Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...

Troubleshooting
Troubleshooting Symptom Suspect area Engine will not start or struggle to start Vapor hose damaged or disconnected Engine strugg ...

Hyundai Accent Manuals


В© 2011-2024 Copyright www.hamanual.com