Hyundai Accent Manuals

Hyundai Accent: PODS-F Zeroing procedure - Passive Occupant Detection System (PODS-F). Repair procedures - SRSCM - Restraint (Advanced)Hyundai Accent: PODS-F Zeroing procedure

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / Passive Occupant Detection System (PODS-F). Repair procedures / PODS-F Zeroing procedure

You should perform PODS-F Re-zero procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly)
1.
Ignition “OFF”, connect GDS.
2.
Ignition “ON” & Engine “OFF”, select Airbag system and “PODS-F Reset” mode.
3.
The GDS will show the two PODS-F Zeroing function steps.
(1)
Erase PODS-F diagnostic codes.
(2)
PODS-F initialization.

This step must be done PODS-F re-zero, when the front passenger seat is empty.
4.
The PODS-F initialization procedure will be performed.

Erase the SRSCM diagnostic codes after completing the PODS-F zeroing.
In case of zeroing failure
-
Code 01 : Requestor ID out of range.
-
Code 02 : ECU faults.
-
Code 03 : ODS sensor short to ground.
-
Code 04 : Open between ODS ECU and mat.
-
Code 05 : ODS ECU has not been trimmed.
-
Code 06 : Configuration disabled in ECU calibration.
-
Code 07 : Configuration value out of range.
-
Code 08 : Used in zero Request response only.
-
Code 09 : Algo enabled this ignition cycles.
-
Code 0A : Upper offset value created during the zero process.
-
Code 0B : Lower offset value created during the zero process.
-
Code 0C : Voltage diagnostic
-
Code 0D : The delta of QX_Freq_Low and QX_Freq_High must remain low.
-
Code 0E : Temperature is above O deg C during the zero process.
-
Code 0F : Re-read QX Final compare delta limit. (zero verify)

Installation
PODS-F ECU 1. Install the PODS-F ECU equipped seat track assembly. (Refer to the Body group - "Seat") 2. Install the ...

Schematic Diagrams
...

See also:

Specifications
Specification Item Resistance (Ω) Driver Airbag (DAB) 1.7 ~ 2.3 Passenger Airbag (PAB) 1.7 ~ 2.3 ...

Circuit Diagram
(M/T) (A/T) ...

High beam operation
To turn on the high beam headlights, push the lever away from you. Pull it back for low beams. The high beam indicator will light when the headlight high beams are switched on. To prevent the ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com