1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable from battery and wait for
at least three minutes before beginning work.
|
3. |
Connect the clock spring harness connector to the clock spring.
|
4. |
Install the steering column shroud.
|
5. |
Set the center position by setting the marks between the clock
spring and the cover into line. Make an array the mark (▶◀) by turning
the clock spring clockwise to the stop and then 2.0 revolutions counterclockwise.
|
6. |
Install the steering wheel.
(Refer to the Steering System group - "Steering Column and Shaft")
|
7. |
Connect the driver airbag (DAB) module connector, and then install
the driver airbag (DAB) module on the steering wheel.
|
8. |
Secure driver airbag (DAB) with the new mounting bolts.
|
9. |
Connect the battery negative cable.
|
10. |
After installing the airbag, confirm proper system operation:
|
Removal
-
When servicing the washer pump, be careful not to damage
the washer pump seal.
...
Installation
•
Do not turn the ignition switch ON and do not contact
the battery cable while replacing the ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the CCV connector.
3.
Measure resistance between the CCV termina ...