Description
Never attempt to measure the circuit resistance of the Seat Belt
Pretensioner (BPT) even if you are using the specified tester. If the
circuit resistance is measured with a tester, the pretensioner will
be ignited accidentally. This will result in serious personal injury.
|
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for
at least three minutes befo ...
Rail Pressure Sensor (RPS). Troubleshooting
Signal Waveform
...
Map lamp
Push the lens (1) to turn the map lamp on or off. This light produces a spot
beam for convenient use as a map lamp at night or as a personal lamp for the driver
and the front passenger.
DOOR ...