1. |
Turn ignition switch OFF.
|
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical group - "Battery")
|
3. |
Disconnect the vacuum hose (A) from the brake booster.
|
4. |
Remove the master cylinder.
(Refer to Master cylinder.)
|
5. |
Remove the snap pin (A) and clevis pin (B).
|
6. |
Remove the brake booster mounting nuts (A).
|
7. |
Disconnect the brake tubes (A) from the HECU by unlocking the
nuts counterclockwise with a spanner.
|
8. |
Remove the brake tubes mounting nuts (A).
|
9. |
Pivot the brake tubes (A) down out of the way.
|
10. |
Remove the brake booster (B).
|
Installation
•
Do not turn the ignition switch ON and do not contact
the battery cable while replacing the ...
Removal
Side Impact Sensor
1.
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
2.
Remove the d ...
Fuel Tank Pressure Sensor
(FTPS). Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...