1. |
Turn ignition switch OFF.
|
2. |
Remove the crash pad lower panel.
(Refer to the Body group - "Crash pad")
|
3. |
Disconnect the stop lamp switch connector (A).
|
4. |
Remove the shift lock cable (B) after removing the snap pin and
the clip.
|
5. |
Remove the BCM.
(Refer to the Body Electrical group - "BCM".)
|
6. |
Remove the mounting bracket bolts (B).
|
7. |
Remove the snap pin (A) and clevis pin (B).
|
8. |
Remove the brake pedal member assembly mounting nuts (A) and then
remove the brake pedal assembly.
|
Front Strut Assembly. Components
and Components Location
Components
•
Tighten with specifed torque at curb position of vehicle
...
Fuses
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one located in the driver’s side panel bolster,
the other in the engine ...
Removal
Side Impact Sensor
1.
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
2.
Remove the d ...