Front Brake Disc Thickness Check |
1. |
Check the brake pads for wear and fade.
|
2. |
Check the brake disc for damage and cracks.
|
3. |
Remove all rust and contamination from the surface, and measure
the disc thickness at 8 points, at least, of same distance (5mm) from
the brake disc outer circle.
|
4. |
If wear exceeds the limit, replace the discs and pad assembly
left and right of the vehicle.
|
Front Brake Pad Check |
1. |
Check the pad wear. Measure the pad thickness and replace it,
if it is less than the specified value.
|
2. |
Check the damage of pad, backing metal and contamination with
grease.
|
Front Brake Disc Runout Check |
1. |
Place a dial gauge about 5mm (0.2 in.) from the outer circumference
of the brake disc, and measure the runout of the disc.
|
2. |
If the runout of the brake disc exceeds the limit specification,
replace the disc, and then measure the runout again.
|
3. |
If the runout does not exceed the limit specification, install
the brake disc after turning it 180В° and then check the runout of the
brake disc again.
|
4. |
If the runout cannot be corrected by changing the position of
the brake disc, replace the brake disc.
|
Installation
1.
Install the rear combination lamp assembly.
2.
Connect the rear combination lamp assembly connector.
3.
Conn ...
Intake Manifold. Components
and Components Location
Components
1. Intake manifold
2. Intake manifold gasket
3. Electronic throttle body gasket
4. Electronic throttle body
5. Bracket
...
For best battery service
Keep the battery securely mounted.
Keep the battery top clean and dry.
Keep the terminals and connections clean, tight, and coated with petroleum
jelly or terminal grease.
Rinse any spil ...