|
1. |
Remove the floor console to reach the adjusting nut.
|
2. |
Loosen the parking brake cable until both operating levers rest
in fully off position.
|
3. |
Bring the brake pads in their operating position by pressing the
brake pedal down several times until there is resistance.
|
4. |
Tension the parking brake cable by tightening the adjusting nut,
until the operating levers on both calipers lift from the stop, up to
a distance of (A) and (D) between operating lever (B) and stopper (C).
|
5. |
Refit the floor console.
|
6. |
Parking brake lever in the car must be in fully loosened position.
|
7. |
If the handbrake cables where changed, actuate the parking brake
a few times with maximum force to stretch the parking brake cables,
and then control adjusting as above.
|
8. |
Check the wheels of their free operation.
|
9. |
Test drive.
|
Reassembly
1.
Install the hub bearing to the knuckle assembly.
(1)
Lay the knuckle assembly (A) on press.
(2)
...
Steering Gear box. Components and
Components Location
Components
1. Tie-rod end
2. Lock nut
3. Bellows clip
4. Bellows
5. Tie rod
6. Rack bar
7. Dust packing
8. Dust cap
9. Oil seal
10. Pinion plug
...
Adjustment
Head Lamp Aiming Instructions
The head lamps should be aimed with the proper beam-setting equipment,
and in accordance with the equipment manufacturer's instructions.
...