|
|
1. |
Raise the rear of the vehicle, and make sure it is securely supported.
|
2. |
Release the parking brake, and remove the rear brake drum.
|
3. |
Check the wheel cylinder (A) for leakage.
|
4. |
Check the brake linings (B) for cracking, glazing, wear, and contamination.
|
5. |
Measure the brake lining thickness (C).Measurement does not include
brake shoe thickness.
|
6. |
If the brake lining thickness is less than the service limit,
replace the brake shoes as a set.
|
7. |
Check the bearings in the hub unit for smooth operation. If it
requires servicing, replace it.
|
8. |
Measure the inside diameter of the brake drum with inside vernier
calipers.
|
9. |
If the inside diameter of the brake drum is more than the service
limit, replace the brake drum.
|
10. |
Check the brake drum for scoring, grooves, and cracks.
|
11. |
Inspect the brake lining and drum for proper contact.
|
12. |
Inspect the wheel cylinder outside for excessive wear and damage.
|
13. |
Inspect the backing plate for wear or damage.
|
Installation
PODS-F ECU
1.
Install the PODS-F ECU equipped seat track assembly.
(Refer to the Body group - "Seat")
2.
Install the ...
General Safety Information and
Caution
Precautions
General Precautions
Please read the following precautions carefully before performing the
airbag system service.
Observe the instructions described in this manual, ...
Removal
1.
Make sure vehicle does not roll before setting room side shift
lever and T/M side manual control lever to "N" position.
2.
Rem ...