Parking Brake Lever Stroke Adjustment |
1. |
Remove the floor console.
(Refer to Body group - "Floor console".)
|
2. |
Remove the floor console rear mounting bracket (A).
|
3. |
Apply a coating of the specified grease to each sliding parts
(A) of the ratchet plate or the ratchet pawl.
|
4. |
Install the parking brake cable adjuster, then adjust the parking
brake lever stroke by turning adjusting nut (A).
|
5. |
Release the parking brake lever fully, and check that parking
brakes do not drag when the rear wheels are turned. Readjust if necessary.
|
6. |
Make sure that the parking brakes are fully applied when the parking
brake lever is pulled up fully.
|
7. |
Install the floor console rear mounting bracket.
|
8. |
Install thd floor console. (Refer to the Body group - "Floor console")
|
Parking Brake Shoe Clearance Adjustment |
1. |
Depress the brake pedal several times to set the self-adjusting
brake.
|
Re-setting of the parking brake is necessary after overhauling
the caliper body, or if the brake calipers, housing, parking brake cable
or brake discs have been changed.
|
1. |
Remove the floor console to reach the adjusting nut.
|
2. |
Loosen the parking brake cable until both operating levers rest
in fully off position.
|
3. |
Bring the brake pads in their operating position by pressing the
brake pedal down several times until there is resistance.
|
4. |
Tension the parking brake cable by tightening the adjusting nut,
until the operating levers on both calipers lift from the stop, up to
a distance of (A) and (D) between operating lever (B) and stopper (C).
|
5. |
Refit the floor console.
|
6. |
Parking brake lever in the car must be in fully loosened position.
|
7. |
If the handbrake cables where changed, actuate the parking brake
a few times with maximum force to stretch the parking brake cables,
and then control adjusting as above.
|
8. |
Check the wheels of their free operation.
|
9. |
Test drive.
|
Engine
...
Intake Air Temperature
Sensor (IATS). Specifications
Specification
Temperature
Resistance (kΩ)
°C
°F
-40
-40
40.93 ~ 48.35
-20
...
Cup holder
WARNING - Hot liquids
Do not place uncovered cups of hot liquid in the cup holder while
the vehicle is in motion. If the hot liquid spills, you may burn yourself. Such
a burn to the driver ...