ESC Hydraulic System Diagram |
1. |
ESC Non-operation : Normal braking.
|
2. |
ESC operation
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
In the event of inhibition of ABS functions by failure.
|
- |
During diagnostic mode.
|
- |
When the ECU Connector is separated from ECU.
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
When the Parking Brake Switch is ON or brake fluid level is low.
|
- |
When the EBD function is out of order .
|
- |
During diagnostic mode.
|
- |
When the ECU Connector is separated from ECU.
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
When the ESC function is inhibited by system failure.
|
- |
When the ESC control is operating. (Blinking - 2Hz)
|
- |
During diagnostic mode.(Except standard mode)
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization mode after IGN ON. (continuously 3 seconds).
|
- |
ESC Off lamp is On when driver input the ESC Off switch.
|
Rear Disc Brake. Components and Components Location
Components
1. Guide rod bolt
2. Bleed screw
3. Caliper carrier
4. Caliper body
5. Brake pad
6. Pad retainer
...
Accelerator Position Sensor
(APS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the ...
Rear Seat. Repair procedures
Replacement
Seat Assembly Replacement
1.
After loosening the mounting bolt, then remove the rear seat cushion
(A).
Tightening torque :
...