1. |
Installation is the reverse of removal.
|
2. |
Tighten the HECU mounting bolts and nuts to the specified torque.
|
3. |
After installation, bleed the brake system.
(Refer to ABS bleeding)
|
Troubleshooting
Failure Diagnosis
1.
In principle, ESC and TCS controls are prohibited in case of ABS
failure.
2.
When ESC or TCS fails, only the failed s ...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Specifications
Specifications
Direct control VFS[OD/B]
▷ Control type : Normal high type
Control Pressure kpa
(kgf/cm², psi)
500.14 ~ 9.81
(5.5 ~ 0.1, 7.82 ~ 1.42) ...
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) fro ...