Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Brake System / ESC(Electronic Stability Control) System / Rear Wheel Speed Sensor. Repair procedures / Removal

1.

Remove the rear wheel and tire.

Tightening torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

2.

Remove the rear wheel speed sensor mounting bolt (A).

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.8 lb-ft)

3.	Remove the rear seat back. (Refer to the Body group - Seat)

4.	Remove the rear wheel housing trim. (Refer to the Body group – interior trim)

5.	Disconnect the rear wheel speed sensor connector.

6.	Installation is the reverse of removal.

Rear Wheel Speed Sensor. Repair procedures

...

Inspection

1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground. ...

See also:

Passenger Airbag (PAB) Module. Description and Operation
Description The passenger airbag (PAB) is installed inside the crash pad and protects the front passenger in the event of a frontal crash. The SRSCM determines if and when to deploy the PAB. ...

ECM Terminal And Input/Output signal [A/T]
ECM Terminal Function (A/T) Connector [EGGA-AG] Pin No. Description Connected to 1 Injector (Cylinder #1) [High] ...

Occupant detection system
Your vehicle is equipped with an occupant detection system in the front passenger's seat. The occupant detection system is designed to detect the presence of a properly-seated front passeng ...

Hyundai Accent Manuals

© 2011-2024 Copyright www.hamanual.com