Projected Dimensions |
1. |
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions
used for body alterations.
|
2. |
If the length of the tracking gauge probes is adjustable, make
the measurement by lengthening one probe by the amount equivalent to
the difference in height of the two surfaces.
|
Actual-Measurement Dimensions |
1. |
These dimensions indicate the actual linear distance between measurement
points, and are the reference dimensions for use if a tracking gauge
is used for measurement.
|
2. |
Measure by first adjusting both probes to the same length (A=A').
|
Measurement Point |
1. |
Measurements should be taken at the hole center.
|
Rubber Parts And Tubes
Always prevent gasoline or from touching rubber parts or
tubing.
...
Power Window Switch. Repair procedures
Inspection
Power Window Main Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim panel.
...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...