|
1. |
After loosening the mounting screws, then remove the tail gate
trim (A).
|
2. |
Installation is the reverse of removal
|
1. |
Remove the tail gate trim.
|
2. |
Disconnect the tail gate latch rods (A).
|
3. |
After loosening the mounting bolts, then remove the latch assembly
(A).
|
4. |
Disconnect the tail gate latch connector (A).
|
5. |
Installation is the reverse of removal
|
1. |
Remove the tail gate trim.
|
2. |
Disconnect the key holder rod (A), then loosen the key holder
(B) mounting bolts and remove.
|
3. |
Installation is the reverse of removal
|
1. |
Remove the tail gate trim.
|
2. |
Disconnect the outside handle rod (A).
|
3. |
After loosening the mounting nuts, then remove the outside handle
(A).
|
4. |
Installation is the reverse of removal
|
|
1. |
Using a screwdriver (A), lift up slightly the socket clips (B)
of both ends on the lifer (D), and then remove the lifter from the bracket
(C).
|
2. |
Push the socket of the lifter into the bracket for installation.
|
|
1. |
Remove the tail gate weatherstrip (A).
|
2. |
Installation is the reverse of removal.
|
SS-B Solenoid Valve(ON/OFF). Description and Operation
Description
SS-B solenoid valve is attached to the valve body and is an on/off solenoid
valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed
at valve body.
...
Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification:
Refer to "Signal Wave Form" section.
...
Side Body B ( 4Door )
Side outer panel notch
Side outer panel notch
Side outer panel notch
...