|
1. |
Remove the glass (A) by lifting it up.
|
2. |
Installation is the reverse of removal.
|
1. |
Remove the roof trim.
(Refer to the BD group - "Roof Trim")
|
2. |
Disconnect the connector (B).
|
3. |
Remove the motor after removing screws from the motor (A).
|
4. |
Installation is the reverse of removal.
|
1. |
Open the glass fully.
|
2. |
Disconnect the deflector link (A) from the frame (B), and then
remove the deflector (C).
|
3. |
Installation is the reverse of removal.
|
1. |
Remove the follows parts.
|
2. |
After loosening the mounting bolts, then remove the assist handle
bracket
|
3. |
Disconnect the drain tubes (B).
|
4. |
After loosening the mounding nuts, remove the sunroof assembly
(A).
|
5. |
Installation is the reverse of removal.
|
1. |
Remove the sunroof assembly.
|
2. |
Remove the drip link (A) and sunshade stopper (B).
|
3. |
Remove the sunshade (C) and drip rail (D).
|
4. |
Installation is the reverse of removal.
|
1. |
Remove the sunroof assembly.
|
2. |
Remove a guide assembly (A) after lowering a guide thoroughly
by pushing a slide to rear.
|
3. |
Remove the guide (A) and slide (B).
|
4. |
Installation is the reverse of removal.
|
Inspection
Multifunction Switch (Lighting)
1.
Disconnect the negative (-) battery terminal.
2.
Remove the lighting switch of the multi-function switc ...
Heated Oxygen Sensor (HO2S). Troubleshooting
Signal Waveform
...
Transaxle Oil Temperature Sensor. Schematic Diagrams
Circuit Diagram
...