Hyundai Accent Manuals

Hyundai Accent: Console. Repair procedures - Interior - Body (Interior and Exterior)Hyundai Accent: Console. Repair procedures

Hyundai Accent RB (2010-2018) Service Manual / Body (Interior and Exterior) / Interior / Console. Repair procedures

Replacement

Floor Console Replacement
[ M/T ]
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the console upper cover (A).
2.
Remove the console tray mat (A).
3.
After loosening the mounting bolt and clips, then remove the floor rear console (A).
4.
Using a screwdriver or remover, remove the floor console front bezel (A).
5.
Disconnect the connectors (A).
6.
After loosening the mounting bolts and nut, clips, then remove the floor front console (A).
7.
Installation is the reverse of removal.
•
Make sure the connector are connected in properly.
•
Replace any damage clips.
[ A/T ]
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Remove the gear knob (A).
2.
Using a screwdriver or remover, remove the console upper cover (A).
3.
Disconnect the connector (A).
4.
Remove the console tray mat (A).
5.
After loosening the mounting bolt and clips, then remove the floor rear console (A).
6.
Using a screwdriver or remover, remove the floor console front bezel (A).
7.
Disconnect the connectors (A).
8.
After loosening the mounting bolts and nut, clips, then remove the floor front console (A).
9.
Installation is the reverse of removal.
•
Make sure the connector are connected in properly.
•
Replace any damage clips.
Armrest Replacement
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the rear console cover (A).
2.
After loosening the mounting screws, then remove the armrest assembly (A).
3.
Installation is the reverse of removal.
•
Replace any damaged clips.

Console. Components and Components Location
Components 1. Floor front console 2. Floor rear console 3. Console upper cover [M/T] 4. Console upper cover [A/T] 5. Floor console front bezel 6. Ash tray 7. ...

Crash Pad. Components and Components Location
Components 1. Main crash pad assembly 2. Side airvent duct [RH] 3. Side airvent duct [LH] 4. Cluster assembly 5. Cluster facia panel 6. Heater control unit 7. ...

See also:

Replacement
1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Clothes hanger
To use the hanger, pull down the upper portion of hanger. CAUTION Do not hang heavy clothes, because it may damage the hook. ...

Economical operation
Your vehicle's fuel economy depends mainly on your style of driving, where you drive and when you drive. Each of these factors affects how many miles (kilometers) you can get from a gallon (l ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com