Replacement
|
1. |
Remove the trunk trim.
(Refer to the BD group - "Trunk Trim")
|
2. |
Disconnect the connector (B) and then loosening the combination
lamp mounting nuts.
|
3. |
Remove the rear combination lamp (A).
|
4. |
After loosening the rear bumper side’s mounting screws, then disconnect
the side’s.
|
5. |
Remove the rear bumper mounting clips.
|
6. |
Loosen the mounting bolts.
|
7. |
Push the lock pin, disconnect the rear bumper main connector (A).
|
8. |
After loosening the mounting screw and clip, then remove the rear
bumper (A).
|
9. |
Installation is the reverse of removal.
|
|
1. |
After loosening the mounting screws, then remove the rear combination
lamp (A).
|
2. |
Push the lock pin, disconnect the connector (B).
|
3. |
After loosening the rear bumper side’s mounting screws, then disconnect
the side’s.
|
4. |
Loosen the mounting clips.
|
5. |
Loosen the mounting bolts.
|
6. |
After loosening the mounting screw and clip, then remove the rear
bumper (A).
|
7. |
Push the lock pin, disconnect the rear bumper main connector (A).
|
8. |
Installation is the reverse of removal.
|
Floor mat anchor
When using a floor mat on the front floor carpet, make sure it attaches to the
floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward.
WARNING
The floor mat must be ...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Specifications
Specifications
Direct control VFS[OD/B]
▷ Control type : Normal high type
Control Pressure kpa
(kgf/cm², psi)
500.14 ~ 9.81
(5.5 ~ 0.1, 7.82 ~ 1.42) ...
Owner maintenance schedule
When you stop for fuel:
Check the engine oil level.
Check coolant level in coolant reservoir.
Check the windshield washer fluid level.
Look for low or under-inflated tires.
Check the radia ...