Replaccement
1. |
After loosening the seat assembly mounting bolts, remove the seat
assembly (A).
|
2. |
Disconnect the connectors (A).
[Driver's]
[Passenger's]
|
3. |
Installation is the reverse of removal.
|
|
1. |
Remove the height cap (A).
|
2. |
After loosening the mounting screws, then remove the height knob
(B).
|
3. |
To remove the recliner handle (A), and then remove the recliner
handle after pushing the lock pin (B).
|
4. |
Pull the lock pin (B).
|
5. |
After loosening the mounting screws, then remove the front outer
shield cover (A).
|
6. |
Installation is the reverse of removal.
|
|
1. |
Remove front seat assembly.
|
2. |
Push the lock pin (B), remove the headrest (A).
|
3. |
Remove the protector (A).
|
4. |
Disconnect the connectors (A).
|
5. |
Push the clips (B) from the seat back cover (A).
|
6. |
Push the protecter (A) by the seat back frame.
|
7. |
Remove the protector (A).
|
8. |
Pull out the headrest guides (A) while pinching the end of the
guides, and remove them.
|
9. |
Remove the protector (A).
|
10. |
Remove the seat back cover (A) from the frame.
|
11. |
After removing the velcro tape (B) on the front of seat back and
remove the seat back cover (A).
|
12. |
Installation is the reverse of removal.
|
|
1. |
Remove front seat assembly.
|
2. |
Remove the front outer shield cover.
|
3. |
Remove the protector (A).
|
4. |
Disconnect the connectors (A).
|
5. |
After loosening the mounting screw, then remove the front inner
side cover (A).
|
6. |
Push the protecter(A), and then seat cushion cover (C) from the
frame(B).
|
7. |
Remove the seat cushion cover (A) from the frame.
|
8. |
After removing the velcro tape (B) on the front of seat cushion
and remove the seat cushion cover (A).
|
9. |
Installation is the reverse of removal.
|
|
1. |
Remove the following items.
|
2. |
After loosening the mounting bolts, then disconnect the seat back
frame (A) and seat cushion frame (B).
|
3. |
Installation is the reverse of removal.
|
Installation
1.
Install the wiper motor.
2.
Install the crank arm.
3.
Install the lower and upper linkage to the wiper motor ...
General Information
General
The supplemental restraint system (SRS) is designed to supplement the
seat belt to help reduce the risk or severity of injury to the driver and passenger
by activating and deploying ...
Repair procedures
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS to check for DTCs. Refer
to the Diagnostic Tr ...