Hyundai Accent: Inspection

Lighting Switch Inspection

With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch.

Lighting switch

HS : Head lamp switch(Short inside)

Dimmer And Passing Switch

HU : Head lamp high beam

HL : Head lamp low beam

HF : Head lamp passing switch

HS : Head lamp switch(Short inside)

Turn Signal Switch

Front Fog Lamp Switch

Wiper And Washer Switch Inspection

With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch.

Wiper Switch (Intermittent)

INT 1 : Intermittent switch 1(Short inside)

INT 2 : Intermittent switch 2(Short inside)

B1 : B1(Short inside)

Wiper Switch

Washer Switch

Repair procedures

...

Removal

Wiper and Washer Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper (A) and lower (B) shrouds aft ...

See also:

Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, or related fuse is blown, you must reset your sunroof system as follows: 1. Turn the ignition switch to the ON position and close the sun ...

For best battery service
Keep the battery securely mounted. Keep the battery top clean and dry. Keep the terminals and connections clean, tight, and coated with petroleum jelly or terminal grease. Rinse any spil ...

Removal
Pressure Side Impact Sensor • Removal of the airbag must be performed according to the ...