Hyundai Accent: Inspection
Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Horn / Repair procedures / Inspection
Horn Inspection
Test the horn by connecting battery voltage to the 2 terminal and ground
the 1 terminal.
1 : 12V Ground(-)
2 : 12V (+)
Take care not to damage the horn when connecting the battery voltage
to the correct terminal.
|
The horn should make a sound. If the horn fails to make a sound, replace
it.
Horn Relay Inspection
| 1. |
Remove the horn relay (A) from the engine room relay box.
|
| 2. |
There should be continuity between the No.30 and No.87 terminals
when power and ground are connected to the No.85 and No.86 terminals.
|
| 3. |
There should be no continuity between the No.30 and No.87 terminals
when power is disconnected.
|
Removal
1.
Remove the mounting bolt and disconnect the horn connector, then
remove the horn (A).
...
See also:
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Lift the vehicle.
3.
D ...
Highway driving
Tires
Adjust the tire inflation pressures to specification. Low tire inflation pressures
will result in overheating and possible failure of the tires.
Avoid using worn or damaged tires which may ...
General
1.
Basically, all measurements in this manual are taken with a tracking
gauge.
2.
When a measuring tape is used, check to be sure there is ...
Hyundai Accent Manuals
В© 2011-2024 Copyright www.hamanual.com