Hyundai Accent: Repair procedures
Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Keyless Entry / Repair procedures
Inspection
Front Door Lock Actuator
| 1. |
Remove the front door trim.
(Refer to the Body group - Front door)
|
| 2. |
Remove the front door latch.
(Refer to the Body group - Front door).
|
| 3. |
Disconnect the connectors from the actuator.
|
| 4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
Rear Door Lock Actuator
| 1. |
Remove the rear door trim.
(Refer to the Body group - Rear door)
|
| 2. |
Remove the rear door latch.
(Refer to the Body group - Rear door)
|
| 3. |
Disconnect the connectors from the actuator.
|
| 4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
Front Door Lock Switch
| 1. |
Remove the front door trim.
(Refer to the Body group - Front door)
|
| 2. |
Remove the front door latch.
(Refer to the Body group - Front door).
|
| 3. |
Disconnect the connectors from the actuator.
|
| 4. |
Check for continuity between the terminals in each switch position
when inserting the key into the door according to the table.
|
Rear Door Lock Switch
| 1. |
Remove the rear door trim.
(Refer to the Body group - Rear door)
|
| 2. |
Remove the rear door latch.
(Refer to the Body group - Rear door)
|
| 3. |
Disconnect the connectors from the actuator.
|
| 4. |
Check for continuity between the terminals in each switch position
according to the table.
|
Trunk lid release actuator
| 1. |
Disconnect the negative battery terminal.
|
| 2. |
Remove the rear trunk lid trim, and then remove the trunk lid
switch from the actuator.
|
| 3. |
Check for continuity between the terminals in each switch position
according to the table.
|
Door switch
Remove the door switch and check for continuity between the terminals.
Door warning switch
| 1. |
Remove the steering column upper (A) and lower (B) shrouds after
removing 3 screws.
|
| 2. |
Disconnect the connector (6p) from the door warning switch.
|
| 3. |
Check for continuity between the terminals in each position according
to the table.
|
Function
Keyless Entry Function
DOOR LOCK / UNLOCK are performed with remote controller.
1.
Keyless entry function is performed in a state that key in switch
is eliminated ...
Transmitter. Specifications
Specifications
Item
Specification
Rated voltage
DC 3V
Service voltage range
DC 2.7V ~ 3.5V
Temperatu ...
See also:
Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
...
Opening the fuel filler lid
The fuel filler lid must be opened from inside the vehicle by pulling the fuel
filler lid opener switch.
NOTICE
If the fuel filler lid will not open because ice has formed around it, tap
ligh ...
Electric power steering (EPS)
The power steering uses a motor to assist you in steering the vehicle. If the
engine is off or if the power steering system becomes inoperative, the vehicle may
still be steered, but it will requi ...
Hyundai Accent Manuals
В© 2011-2024 Copyright www.hamanual.com