Inspection
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
3. |
Disconnect the connector from the power window switch module.
|
4. |
Check for continuity between the terminals in each switch position
according to the table.
|
Repair procedures
Troubleshooting
Starter Circuit
The battery must be in good condition and fully charged.
1.
...
Rubber Parts And Tubes
Always prevent gasoline or from touching rubber parts or
tubing.
...
Satellite radio reception
You may experience problems in receiving XMв„ў satellite radio signals in the following
situations.
If you are driving in a tunnel or a covered parking area.
If you are driving beneath the t ...