1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the trunk lower trim.
(Refer to the BD group - " Trunk Lid")
|
3. |
Disconnect the rear combination lamp connector (A). Remove the
rear combination lamp assembly (B) after loosening 3 nuts.
|
4. |
Remove the bulb after turning in the counterclockwise direction.
A : Tail Lamp / Stop Lamp
B : Turn Signal Lamp
C : Back Up Lamp
D : Side marker
|
5. |
If necessary to remove the bulb, remove the bulb after pulling
the trim cover aside.
[Tail Lamp / Stop Lamp]
[Turn Signal Lamp]
[Back up Lamp]
[Side marker]
|
Replacement
Standard values, such as torques and certain adjustments,
must be strictly observed in the reassembly of all parts.
If removed, the following parts should always be replaced
with new ones ...
Removal
The side airbag cannot be disassembled from the seat back assembly,
so replace assembly when replacing the side airbag.
...
Installation
1.
Install the power window switch module.
2.
Install the door trim panel after reconnecting the relevant connectors
...