When heavy rear components such as suspension, fuel
tank, spare tire, tailgate and trunk lid are to be removed, place additional
weight in the luggage area before hoisting. When substantial weight
is removed from the rear of the vehicle, the center of gravity may change
and can cause the vehicle to tip forward on the hoist.
|
|
1. |
Place the lift blocks under the support points as
shown in the illustration.
|
2. |
Raise the hoist a few inches (centimeters) and rock
the vehicle to be sure it is firmly supported.
|
3. |
Raise the hoist to full height to inspect the lift
points for secure support.
|
ETC (Electronic Throttle
Control) System. Specifications
Specification
[Throttle Position Sensor (TPS)]
Throttle angle(°)
Output Voltage (V)
TPS1
TPS2
0
0.5
4.5
...
Exhaust Manifold. Components
and Components Location
Components
1. Heat protector
2. Exhaust manifold
4. Exhaust manifold gasket
5. Exhaust manifold stay
...
Removal
1.
Disconnect the brake fluid level switch connector, and remove
the reservoir cap.
2.
Remove the brake fluid from the master cylinder res ...