• |
Adjust a shift cable.
|
• |
Refill engine with engine oil.
|
• |
Refill a transaxle with fluid.
|
• |
Refill power steering fluid.
|
• |
Refill a radiator and a reservoir tank with engine
coolant.
|
• |
Clean battery posts and cable terminals and assemble.
|
• |
Inspect for fuel leakage.
|
- |
After assemble the fuel line, turn on the ignition
switch (do not operate the starter) so that the fuel pump runs for approximately
two seconds and fuel line pressurizes.
|
- |
Repeat this operation two or three times, then check
for fuel leakage at any point in the fuel line.
|
• |
Bleed air from the cooling system.
|
- |
Start engine and let it run until it warms up. (until
the radiator fan operates 3 or 4 times.)
|
- |
Turn Off the engine. Check the level in the radiator,
add coolant if needed. This will allow trapped air to be removed from
the cooling system.
|
- |
Put radiator cap on tightly, then run the engine
again and check for leaks.
|
Front Body E ( 5Door )
Hood hinge mounting hole (Ø10)
Fender apron upper member tooling
hole (Ø6.6)
Cowl under ...
Description of ESC
Optimum driving safety now has a name : ESC, the Electronic Stability
Control.
ESC recognizes critical driving conditions, such as panic reactions in
dangerous situations, and stabili ...
Changing tires
1. Park on a level surface and apply the parking brake firmly.
2. Shift the shift lever into R (Reverse) with manual transaxle or P (Park) with
automatic transaxle.
3. Activate the hazard warnin ...