Water Pump |
1. |
Drain engine coolant.
|
2. |
Loosen the alternator tension adjusting bolt (A)
to loosen tension.
|
3. |
Remove the drive belt (A).
|
4. |
Remove the water pump pulley (A).
|
5. |
Remove the water pump (A).
|
6. |
To install, reverse the removal orders.
|
7. |
Fill with engine coolant.
|
8. |
Start engine and check for leaks.
|
9. |
Recheck engine coolant level.
|
1. |
Drain engine coolant.
|
2. |
Disconnect the battery negative terminal.
|
3. |
Remove the air duct and air cleaner assembly. (Refer
to Engine and transaxle assembly)
|
4. |
Disconnect the engine coolant temperature sensor
connector (A).
|
5. |
Disconnect the radiator upper hose (A).
|
6. |
Disconnect the heater hoses (A).
|
7. |
Remove the water temperature control assembly (B)
after disconnecting the bypass hose (A).
|
8. |
Remove the intake manifold. (Refer to Intake and
exhaust system)
|
9. |
Remove the heater pipe (A).
|
10. |
To install, reverse the removal orders.
|
Curtain Airbag (CAB) Module. Components
and Components Location
Components
...
SRS Control Module (SRSCM). Description and
Operation
Description
The primary purpose of the SRSCM (Supplemental Restraints System Control
Module) is to discriminate between an event that warrants restraint system deployment
and an event that d ...
Side Airbag (SAB) Module. Description
and Operation
Description
The Side Airbags (SAB) are installed inside the front seat and protects
the driver and passenger from danger when side crash occurs. The SRSCM determines
deployment of side airba ...