Inspection
1. |
Check the continuity between the terminal and the
body with an ohmmeter. If there is no continuity, replace the oil pressure
switch.
|
2. |
Check the continuity between the terminal and the
body when the fine wire is pushed. If there is continuity even when
the fine wire is pushed, replace the switch.
|
3. |
If there is no continuity when a 49.0kpa (0.5kg/cm²,
7.1psi) is applied through the oil hole, the switch is operating properly.
Check for air leakage. If air leaks, the diaphragm
is broken. Replace it.
|
SRS Control Module (SRSCM). Description and
Operation
Description
The primary purpose of the SRSCM (Supplemental Restraints System Control
Module) is to discriminate between an event that warrants restraint system deployment
and an event that d ...
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below ...
Installation
1.
Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve
upward.
2.
Install the water inlet fitting ( ...