Hyundai Accent Manuals

Hyundai Accent: Specifications - General Information - Engine Electrical SystemHyundai Accent: Specifications

Specifications

Ignition System
Items
Specification
Ignition coil
Primary resistance
0.7 ± 15 % (Ω)
Secondary resistance
5.9 (kΩ)
Spark plugs
Type
SILZKR6B10E
Gap
1.0 ~ 1.1 mm (0.0394 ~ 0.0433in.)

Starting System
Items
Specification
Starter
Rated voltage
12V, 0.9kW
No. of pinion teeth
8
No-load characteristics
Voltage
11.5V
Ampere
60A, MAX
Speed
5,500rpm, MIN

Charging System
Items
Specification
Alternator
Rated voltage
13.5V, 90A
Speed in use
1,000 ~ 18,000rpm
Voltage regulator
IC Regulator built-in type
Regulator setting voltage
External mode
ECU control
Internal mode
 14.55 ± 0.3V
Temperature compensation
External mode
ECU control
Internal mode
-3.5 ± 2mV / °C
Battery
Type
36 - 20 GL
Cold cranking amperage
410A
[at -18°C (-0.4°F)]
Reserve capacity
80min
Specific gravity [at 25°C(77°F)]
1.280 ± 0.01

•
COLD CRANKING AMPERAGE is the amperage a battery can deliver for 30 seconds and maintain a terminal voltage of 7.2V or greater at a specified temperature.
•
RESERVE CAPACITY RATING is amount of time a battery can deliver 25A and maintain a minimum terminal voltage of 10.5V at 26.7°C(80.1°F).


General Information
...

Troubleshooting
Troubleshooting Starting System Symptom Suspect area Remedy Engine will not crank Battery charge low Charge or replace batt ...

See also:

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lower trim. (Refer to the BD group - " Trunk Lid") ...

Inspection
1. Inspect diaphragm spring wear which is in contact with a concentric slave cylinder bearing. 2. Check the clutch cover and disc surface f ...

Jack and tools
The jack, jack handle, and wheel lug nut wrench are stored in the luggage compartment. Pull up the luggage box cover to reach this equipment. (1) Jack (2) Jack handle (3) Wheel lug nut wrench ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com