1. |
Make sure the ignition switch and all accessories
are in the OFF position.
|
2. |
Disconnect the battery cables (negative first).
|
3. |
Remove the battery from the vehicle.
|
4. |
Inspect the battery tray for damage caused by the
loss of electrolyte. If acid damage is present, it will be necessary
to clean the area with a solution of clean warm water and baking soda.
Scrub the area with a stiff brush and wipe off with a cloth moistened
with baking soda and water.
|
5. |
Clean the top of the battery with the same solution
as described above.
|
6. |
Inspect the battery case and cover for cracks. If
cracks are present, the battery must be replaced.
|
7. |
Clean the battery posts with a suitable battery post
tool.
|
8. |
Clean the inside surface of the terminal clamps with
a suitable battery cleaning tool. Replace damaged or frayed cables and
broken terminal clamps.
|
9. |
Install the battery in the vehicle.
|
10. |
Connect the cable terminals to the battery post,
making sure tops of the terminals are flush with the tops of the posts.
|
11. |
Tighten the terminal nuts securely.
|
12. |
Coat all connections with light mineral grease after
tightening.
|
Installation
1.
Install the power window switch module.
2.
Install the door trim panel after reconnecting the relevant connectors
...
Manifold Absolute Pressure
Sensor (MAPS). Specifications
Specification
Pressure
[kPa (kgf/cm², psi)]
Output Voltage (V)
20.0 (0.20, 2.9)
0.79
46.7 (0.47, 6.77)
1.84
...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...