Hyundai Accent: Disassembly
| 1. |
Disconnect the M-terminal (A) on the magnet switchassembly.
|
| 2. |
After loosening the 2 screws (A), detach the magnetswitch
assembly (B).
|
| 3. |
Loosen the through bolts (A).
|
| 4. |
Remove the rear bracket (A) and brush holderassembly
(B).
|
| 5. |
Remove the yoke (A).
|
| 6. |
Remove the packing (A), lever plate (B), lever (C)
and the armature (D).
|
| 7. |
Press the stopper (A) using a socket (B).
|
| 8. |
After removing the stop ring (A) using stopper pliers(B).
|
| 9. |
Remove the stop ring (B), stopper (A), overrunningclutch
(C) and armature (D).
|
| 10. |
Reassembly is the reverse of disassembly.
|
Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque
(-) terminal :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4l ...
Inspection
Armature
1.
Remove the starter.
2.
Disassemble the starter as shown at the beginning
of this procedure.
3 ...
See also:
Inspection
•
Frequent inhalation of brake pad dust, regardless of material
composition, could be hazardo ...
Removal
Door Mirror Turn Signal Lamp
1.
Remove the mirror (A) from the mirror holder. Be careful not to
damage to the clip.
2.
Remove ...
Fuel Pressure Control Valve. Repair procedures
Inspection
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the fuel pressure regulator valve ...
Hyundai Accent Manuals
В© 2011-2024 Copyright www.hamanual.com