Hyundai Accent: Removal
When replacing the ECM, the vehicle equipped with
the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer system")
2) After finishing "ECM Neutral mode", perform "Key
teaching" procedure with GDS. (Refer to Body Electrical System - "Immobilizer
system")
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS. (Refer
to Body Electrical System - "Immobilizer system")
|
| 1. |
Turn ignition switch OFF and disconnect the negative
(-) battery cable.
|
| 2. |
Disconnect the ECM Connector (A).
|
| 3. |
Remove the battery (Refer to "Charging System" in
EM group).
|
| 4. |
Remove the mounting bolts and nut, and then remove
the ECM bracket assembly (A).
|
Installation
When replacing the ECM, the vehicle equipped with
the immobilizer must be performed procedure as below.
[In the ...
See also:
Inspection
Horn Inspection
Test the horn by connecting battery voltage to the 2 terminal and ground
the 1 terminal.
1 : 12V Ground(-)
2 : 12V (+)
...
Installation
1.
Installation is the reverse of removal.
2.
Use a SST (09581-11000) when installing the brake caliper assembly.
3 ...
Meaning Of Symbols
There are five primary symbols used to complement illustrations.
These symbols indicate the part to apply such materials during service.
Symbol
Meaning
...
Hyundai Accent Manuals
В© 2011-2024 Copyright www.hamanual.com