When replacing the ECM, the vehicle equipped with
the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer system")
2) After finishing "ECM Neutral mode", perform "Key
teaching" procedure with GDS. (Refer to Body Electrical System - "Immobilizer
system")
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS. (Refer
to Body Electrical System - "Immobilizer system")
|
1. |
Installation is reverse of removal.
|
Underdrive Brake Control Solenoid Valve(UD/B_VFS). Specifications
Specifications
Direct control VFS[UD/B]
▷ Control type : Normal high type
Control Pressure kpa
(kgf/cm², psi)
500.14 ~ 9.81
(5.5 ~ 0.1, 7.82 ~ 1.42) ...
Replacement
Problems And Replacement Parts:
Problem
Part set
GDS required?
All keys have been lost
Blank key (4)
YES
An ...
Troubleshooting
Troubleshooting
Symptom
Suspect area
Engine will not start or struggle to start
Vapor hose damaged or disconnected
Engine strugg ...